Fel-Pro PermaTorque MLS head gasket for Subaru WRX and STI

Fel-Pro Gaskets for Subaru: Head Sets, Conversion Sets, and Seals

Every engine job disturbs gaskets and seals, and the rule is simple: a disturbed seal gets replaced, never reused. Fel-Pro is the OE-pattern replacement line — head gasket sets, conversion sets, valve cover sets, and every small seal down to the drain plug — and Crawford carries it for WRX and STI. Where Cometic is the performance MLS shelf (see the Cometic guide), Fel-Pro is the by-the-book reseal for stock and street engines.

Crawford First: Our Own Installation Kits

Start where Crawford starts. Every Crawford built short block is assembled here on a brand-new OEM case, with its gaskets and seals specified and recorded on the build sheet — buy the motor and the sealing is already handled. Installing one yourself? Crawford's own EJ25 Short Block Installation Kit ($799.95; 2004–2006 at $799.99) and FA20DIT Installation Kit ($699.99) carry the complete gasket and seal set for the install, by application, EJ20/EJ25 Hybrid and FA20 versions included ($699.95–$799.99). That is the Crawford answer, and it comes first. The shelf below is for building or resealing a motor that isn't ours.

Head Gasket Sets

Conversion Sets: The Bottom End

Valve Covers, Intakes, and Turbo Gaskets

Seals: The Rest of the Shelf

Camshaft seal kits from $14.51, crankshaft seal kits from $12.05, valve stem seal sets $25.07–$45.56, oil pan gasket sets from $9.94, water pump gaskets from $4.21, down to the oil cooler seal at $3.18 and the drain plug gasket at $3.28. Small money, all of it — and each one is a comeback if it's skipped. Gaskets and seals are line items on every Crawford build for a reason: they're recorded on the build sheet like everything else that goes into the motor.

FAQ

Head set or conversion set — which do I need? They're halves of the same job. Head set covers the top end, conversion set covers the bottom. A full reseal takes both.

Are Fel-Pro head gaskets MLS? The PermaTorque line is MLS, yes — OE-pattern multi-layer steel, built for stock and street-duty engines. High-boost builds spec from the Cometic shelf instead.

Why not just reuse the old seals if they look fine? Because "looks fine" is how an engine comes back apart for a $12 seal. Seals take a set and harden with heat cycles; the labor to reach them costs a hundred times the part.

Do the FA20 listings that mention FR-S/86 fit my WRX? Yes — the FA20 is shared across the WRX and the BRZ/FR-S/86 twins, and those listings carry the WRX fitment in their titles (2015–2020/2021). Match the years to your car.

Back to blog