Crawford-built Subaru engine

STI Aftermarket Parts: The Ultimate Buyer's Guide

An STI build is a system, not a pile of parts. Power, protection, and the parts that carry them have to be planned together, in the right order. This guide covers what Crawford builds for the STI, what each piece does, what it costs to get started, and where the honest limits are.

Start With Protection: The Air/Oil Separator

The first part on a modified STI should be an air/oil separator. Under boost, crankcase pressure pushes oil vapor into the intake. That oil lowers the effective octane of the charge and leaves deposits. An AOS separates the oil from the vapor and returns it to the crankcase.

Crawford developed the original closed-loop Subaru AOS. It drains back automatically — there is no can to empty. Crawford's AOS runs about $450 and installs with basic tools. One caution, stated plainly: Crawford's AOS carries no CARB EO. Check the EO status for your application before you buy.

Exhaust

A cat-back exhaust replaces everything from the catalytic converter back. The factory system is built for quiet, and it restricts flow. A Crawford cat-back uses larger piping and less restrictive mufflers. The gains are modest — the real returns are throttle response and sound. Expect the deep boxer rumble the factory system was designed to hide.

An axle-back replaces only the muffler section. It is a sound part: one or two horsepower at most, and under an hour to install with hand tools. Cat-back and axle-back are alternatives, not a pair. Pick the one that matches the goal.

Built and BTO Engines

Past the stock internals' limits, the answer is a built engine. Every Crawford motor starts from a brand-new OEM block. No core is required or needed. CrawfordSPEC pistons are forged by JE Pistons.

The current line:

  • CrawfordSPEC CSS 540 — 450 whp / 540 bhp
  • Club Racer CCR 660 — 550 whp / 660 bhp
  • Racer Spec CRS 720+ — 600+ whp / 720+ bhp

The legacy stage-named blocks sit below that line under their own names: the S2 (450 whp), the S3L-X (550 whp), and the S3L-X FSR (600+ whp). They are legacy products, not renamed versions of the current line.

Short blocks and long blocks are both available, in built and BTO — Better Than Original — form. Crawford-built long blocks ship free.

Every built engine carries a 1-year / 12,000-mile warranty. The conditions are part of the deal: break the engine in on the spec — oil changes at 500 and 1,500 miles, engine speed between 2,000 and 4,500 RPM and varied, no sustained cruising or full-throttle pulls, no more than 80% of target boost until break-in is complete — and the first oil analysis is mandatory. It is a warranty condition, not a suggestion.

A larger turbo on stock internals is the classic STI failure path. The engine comes first. The turbo is sized to the engine, not the other way around.

Cylinder Head Packages

Heads decide how much air the engine can move. Crawford's head packages — Rebel, Bandit, and Outlaw — cover the range from a street build to a fully built engine, with porting and valvetrain work matched to the package level. The Outlaw is the package for engines pushing over 700 horsepower. Head work belongs in the same plan as the short block: airflow in and out has to match the bottom end under it.

What Crawford Does Not Sell

A buyer's guide should say this plainly.

  • Brakes. Pads, rotors, and lines sized for stock power will not hold up to a built car. Crawford does not sell brakes.
  • Suspension. Coilovers, springs, and sway bars are how the chassis keeps up with the engine. Crawford does not sell suspension.
  • Wheels and tires. Wider, stickier rubber is part of using added power. Crawford does not sell wheels or tires.
  • Aero, lighting, and interior. Splitters, wings, lighting, and cabin parts are personalization, not performance hardware. Crawford does not sell them.

Budget for those categories with whoever you buy them from. Do not let them crowd out the engine work.

A Professional Tune Is Not Optional

Hardware changes the engine's air and fuel requirements. The factory ECU calibration does not know the new parts are there. Any part that changes airflow — exhaust, turbo, engine — requires a professional tune, or the engine runs lean and gets hurt.

Crawford does not sell tuning. Plan the tune, and the tuner, as part of the build budget from the start.

Choosing Parts That Last

  • Fitment is generation-specific. Parts are engineered for a model and year range. Confirm yours before you order.
  • Materials matter. Billet aluminum and high-grade stainless steel outlast cheaper alternatives. A part that fails costs more than the part that cost more.
  • Support matters. Buy from a manufacturer you can reach, with a warranty behind the part.
  • JDM parts carry a risk. Parts built for Japanese-market cars can differ in fitment and wiring, and they rarely come with warranty support on this side of the Pacific.

Crawford is the only aftermarket manufacturer ever factory-backed by Subaru of America. That is the record the parts are built on.

Budgeting in Stages

  • Under $2,000. The AOS (about $450) and a strut tower brace (about $200) are the honest first moves: protection and steering feel, both bolt-on.
  • $2,000 to $8,000. A full exhaust system and the supporting work around it. This is the range where a professional tune becomes part of the spend.
  • Over $8,000. Built short blocks, long blocks, head packages, and the turbo and fuel system to match. This is a planned build, not a shopping trip.

Crawford-made parts carry one price, labeled MSRP. There are no sales to wait for. The price is what it cost to make the part right.

Installation

Air/oil separators, strut tower braces, and cat-back exhausts are garage jobs with a basic toolset. Engine internals, head work, and turbochargers are professional jobs — specialized tools, measured tolerances, and no margin for a learning curve. Confirm compatibility for your year and model before anything is ordered or installed.

Common Myths

More expensive always means better. Not automatically. Value is durability and fit, not the price tag. A cheap part that fails and takes other parts with it is the most expensive option on the list.

One magic part transforms the car. No single part adds 100 horsepower. Gains come from a combination of parts that support each other, tuned to work together.

Popular means proven. The parts that last are the ones engineered for the platform and backed by the company that made them. Start with protection, build the engine before the turbo, and tune it when the hardware changes.

Related Reading

Questions on a build: (855) 677-8243 | crawfordperformance.com

Related reading: BRZ Aftermarket Parts: A Complete Buyer's Guide.

Back to blog