Subaru Performance Upgrades: What to Mod First
Share
Power is useless without control, and neither matters if the engine doesn't stay healthy. A good build treats the car as a complete system. The order matters as much as the parts: protect the engine first, add power in steps the motor can support, and finish with a built engine only when the stock one has become the limit.
Define your goal before you buy. A track car, an overlanding rig, and a spirited daily driver take different parts. Decide first, and every part you choose works toward the same end.
Start with the Known Weak Points
Even reliable Subarus have known failure points. Fixing one with a stock part gets you back to where you started. Fixing it with a better part leaves the car stronger than it was.
Head Gaskets (EJ Series)
On EJ engines — WRX and STI, 2002–2014 — head gasket failure is a known concern. The original factory gasket was a single layer that wore out around 120,000–150,000 miles. When the seal between the block and the head fails, coolant leaks and the engine overheats. The fix is a multi-layer steel (MLS) head gasket. It seals better and holds up under the increased cylinder pressure of a modified engine.
Oil in the Intake (FA/FB Series)
The FA and FB engines in the WRX, Forester, and Crosstrek use low-tension piston rings for fuel efficiency. Oil gets past them — burned in the combustion chamber or pulled through the PCV system into the intake, where it causes carbon buildup and costs power. An Air/Oil Separator (AOS) captures oil vapor from the crankcase and returns it to the oil pan, so only clean air re-enters the intake. Crawford developed the original closed-loop Subaru AOS. It needs no maintenance and never needs draining. Note: Crawford's AOS has no CARB EO — check EO status for your state before ordering.
Timing Belt
Subaru recommends replacing the timing belt every 95,000–105,000 miles. If it breaks, the engine is severely damaged. When the belt is done, inspect the tensioners and pulleys and replace what is worn. On a modified engine running higher RPM and more load, this is not a job to stretch.
The Mod Order
1. Air/Oil Separator
The AOS is the first mod on any turbo Subaru. It protects the engine before you add power: no oil in the intake, no oil coating the intercooler, knock resistance preserved. It is a foundational part, and it stays on the car through every later stage of the build. Bolt-on install, no tune required.
2. Billet Power Blocks
For naturally aspirated cars — Crosstrek, Impreza, Forester, and the 2013–2021 BRZ/FR-S/GT86 — Crawford Billet Power Blocks are the next step. They go between the intake manifold and the heads, lengthen the intake runners, and move the powerband down. The gain is about 15 hp, with more power down low where you drive every day. They work with the stock intake. There is no dyno chart for them — the improvement is in low-end response, and that is what you feel.
3. Exhaust
A cat-back exhaust reduces backpressure, frees up power, and gives the car the boxer sound. It is a bolt-on step that needs no supporting changes. Choose the sound you want to live with every day — a good system is deep under acceleration and quiet enough at cruise.
4. Supporting Systems
Power is only part of a build. Brakes and suspension have to match it. As power climbs, upgrade brake pads and rotors so the car stops as well as it goes, and address suspension wear and alignment so the chassis stays predictable. These are supporting systems, not the headline — but skipping them makes a faster car a worse one.
5. A Built Engine
When the stock engine becomes the limit, the answer is a built one. Crawford short blocks and long blocks start from brand-new OEM blocks — no core required or needed. The CrawfordSPEC pistons are forged by JE Pistons. The FA20 DIT short block is rated at 660 hp. Crawford-built long blocks ship free. Built engines carry a 1-year / 12,000-mile warranty; break-in and the first oil analysis are mandatory conditions of that warranty. Break-in: oil changes at 500 and 1,500 miles, engine speed between 2,000 and 4,500 RPM and varied, no sustained cruising or full-throttle pulls, and no more than 80% of target boost until break-in is complete.
Any hardware change that alters airflow needs a professional tune to run safely. Crawford does not sell tuning services — budget for a tune with a tuner who knows the platform whenever the build calls for one.
Priorities by Driving Style
Daily driver. AOS first. Then a cat-back for sound and response. Keep the car comfortable and reliable — every mod should be one you can live with in traffic, every day.
Track and canyon. AOS, then brakes and suspension sorted before more power. A car that stops and turns carries speed a powerful car on stock brakes cannot. The built engine comes last, when you have the chassis to use it.
Off-road and overlanding. Start with a lift kit and all-terrain tires for clearance and traction, then skid plates to protect the engine, transmission, and rear differential. The AOS matters here too — steep climbs and descents are hard on oil control, and it protects the engine far from help. More in the Crosstrek overland parts checklist.
WRX and STI
The WRX and STI path follows the same order. AOS first — on the FA20 cars it also fights the carbon buildup direct injection causes; see the FA20 reliability mods that matter most. Exhaust next. Then, when the build outgrows the stock block, a built short block or long block. The mistake to avoid is chasing a horsepower number on a stock engine with no protection and no plan. Build the foundation first and the power is reliable when it comes.
Impreza and BRZ
Naturally aspirated cars respond to a different path. Billet Power Blocks for low-end power, a header and exhaust to let the engine breathe, and the FA20 short block options for the BRZ when a build goes further. These are light, balanced cars — mods that add response beat mods that chase peak numbers.
Budget Tiers
$60–$800. The AOS lives here, and it is the smartest first dollar on a turbo car. Small, well-chosen parts that protect the engine and improve feel.
$800–$2,500. Cat-back exhaust, Billet Power Blocks, and the supporting work that sets up the next stage.
$2,500–$12,000. Built short blocks and long blocks, and the overland hardware for a full Crosstrek or Forester build. This is also the tier of the parts that went into builds like Ken Block's Gymkhana cars — serious hardware, bought once, in the right order.
Common Mistakes
Buying without a plan. Parts bought on deals, with no end goal, rarely add up to a good car. Oversized parts fitted "just in case" create problems now for a build that may never come. Define the goal, then buy in order.
Sound over substance. Noise is not power. Some parts are loud and add nothing. Look past sound clips and ask what a part actually does — how it is made, what it changes, what it protects.
Skipping the tune. The ECU is calibrated for stock hardware. Change how the engine breathes and it needs recalibration to run safely and make the power the parts allow. A professional tune is not optional at that point.
Cheap parts. A low-quality part that fails costs the part twice plus labor twice — and if it takes the engine with it, far more. Buy proven parts once.
Why Crawford
Crawford builds Subaru parts and engines, and nothing else. Crawford Performance is the only aftermarket manufacturer ever backed by Subaru of America. The AOS is the original closed-loop design. The engines start from brand-new OEM blocks, and the built engines are backed by the 1-year / 12,000-mile warranty above. Parts are designed to be bought in order and to work together — that is the whole point of the path laid out here.
Simple bolt-ons like the AOS are a reasonable weekend job with basic tools. Engine internals are not — a built engine belongs in professional hands, installed correctly, so the warranty stands. Questions about what fits your car: call (855) 677-8243.
Frequently Asked Questions
What is the single best first upgrade for my Subaru? For turbocharged models like the WRX and STI, the Air/Oil Separator. It protects the engine before any power is added. For naturally aspirated cars like the BRZ or Impreza, Billet Power Blocks — more power down low, on the stock intake.
Do I really need a tune after installing a new part? Not every part. The AOS and Billet Power Blocks do not require one. Anything that changes how the engine breathes does. Skipping it leaves the ECU guessing, and the cost of guessing wrong is an engine.
Can I make my car more responsive without making it loud? Yes. The AOS and Power Blocks add no noise. A quality cat-back adds a deep tone under acceleration without drone at cruise.
What's the most important upgrade for off-roading? A lift kit and all-terrain tires first — clearance and traction. Then skid plates. Then the AOS, for the climbs.
Shopping by goal instead? See performance parts by build goal.