Crawford-built Subaru FA engine

FA24 Engine Reliability: Complete Guide for WRX Owners

The FA24 is the strongest starting point Subaru has ever given the WRX: 2.4 liters, a semi-closed deck, and a torque curve that arrives early and stays. It is also a young engine with known weak points, and reliability comes from knowing which is which.

This guide covers the design, the documented concerns, and what to do about each — including the replacement and upgrade paths Crawford now sells for this engine.

The engine, in numbers

  • 2.4L flat-four, 94 mm bore × 86 mm stroke, 2,387 cc
  • FA24 DIT (2022+ WRX): 271 hp at 5,600 RPM; 258 lb-ft in the WRX, up to 277 lb-ft in other applications, peaking across 2,000–4,800 RPM
  • Semi-closed deck block — the structural upgrade over the open-deck FA20 it replaced. The deck resists cylinder-wall flex under boost, which is the foundation everything else builds on.

Stock FA24 DIT internals are commonly run at 350–400 wheel horsepower with proper supporting modifications before the block itself becomes the conversation. That headroom is real, and it is not unlimited — the concerns below are where it gets spent.

The known concerns

RTV in the oil pickup. Excess silicone sealant from the factory can break loose and collect on the pickup screen, restricting oil flow. It is the FA24's most documented issue, shared with the second-generation BRZ/GR86. The defense is oil pressure awareness and level discipline — the full picture is in our oil starvation guide, which covers the FA24 pickup issue directly.

The plastic charge pipe. The factory charge pipe can blow off under higher boost. It is a clamp-and-plastic problem with a straightforward fix, and it tends to announce itself before it strands you — a boost leak and a sudden loss of power, not a destroyed engine.

Direct injection carbon. Like every DI engine, the FA24 builds carbon on the intake valves over time because no fuel washes them. Oil vapor management matters here as much as on any turbo Subaru — Crawford's AOS collection is the starting point, and Cody Woodruff's AOS article explains the system.

Heat and oil discipline. Turbo engines live or die on oil: level, condition, and change intervals. The FA24 is not fragile. It is unforgiving of neglected oil, especially tuned.

When the engine is the problem

Diagnosis first, always. But when an FA24 is worn, damaged, or done, Crawford's FA24 line is now live:

For the naturally aspirated FA24 (BRZ/GR86 and others), the same ladder exists: OEM FA24 short block at $2,403.00, and BTO short and long blocks in the catalog.

Every Crawford FA24 motor starts from a brand-new OEM block — no core charge, no core return, no used block. Built-to-order motors carry a 1-year / 12,000-mile warranty, and the break-in procedure with its mandatory first oil analysis is a condition of that coverage. When the build needs a tune to match, Crawford recommends Delicious Tuning.

Questions on an FA24: (855) 677-8243.

The pickup defense

For the RTV problem specifically, Crawford stocks the Killer B Motorsport pickup pre-filters: WRX 2022+ at $56.00 and BRZ 2022+ at $54.00 — a screen ahead of the pickup, in the Killer B Motorsport collection.

Frequently asked questions

Is the FA24 reliable? Yes, with maintenance. The semi-closed deck and factory internals give it genuine headroom — commonly 350–400 whp with supporting mods. Its documented issues (RTV in the pickup, the plastic charge pipe, DI carbon) are known, watchable, and fixable.

What is the FA24's biggest weakness? Oil supply. Factory RTV collecting on the pickup screen is the failure that hurts engines; oil level and pressure awareness is the defense.

Does Crawford sell built FA24 motors? Crawford sells the BTO line: brand-new OEM blocks with every bearing upgraded, as short blocks and complete long blocks. They are stock-replacement motors done better than stock — not forged racing builds, and Crawford says so on the listings.

How much power can a stock FA24 DIT handle? With proper supporting modifications and a matched tune, 350–400 wheel horsepower is the commonly run range before the block becomes the limiting factor.

Building the car around the motor? The full path is in the VB WRX upgrades guide.

Complete the Build: Oil Control and Break-In

A fresh motor lives or dies on oil control and break-in. The FA24 DIT runs the dual-chamber V3 — a Crawford air oil separator keeps oil out of the intake, and the first fills run on Motul break-in oil — oil changes at 500 and 1,500 miles, per the Crawford break-in spec.

Back to blog