BLOX Racing for Subaru: Silicone Turbo Inlets, Couplers, and Rear Control Arms
Share
Not every useful part is expensive. BLOX Racing's Subaru line is mostly silicone and steel — the hoses and couplers that age out on a turbo car, plus one genuinely important chassis piece. Crawford carries the line; here is what matters in it.
The Chassis Piece: Rear Lower Control Arms
- BLOX Racing Rear Lower Control Arms — WRX 2008–2023 — $311.95 (black, red, or teal). The factory rear arms offer no camber adjustment; lower a WRX or STI and rear camber lands where it lands. These arms make it adjustable — which makes them an alignment part, and the reason they're in this guide at all. They pair with the toe and bushing work in our Whiteline and Cusco guide.
Silicone Turbo Inlet Hoses
The factory turbo inlet is plastic and rubber, and on a 2015–2021 WRX it is now old — heat-cycled, oil-misted, and prone to tearing at the turbo connection, which is an unmetered-air leak the engine feels immediately.
- BLOX Racing Silicone Turbo Inlet Hose 3in High Power — WRX 2015–2020 — $164.75 (black, red, or blue).
- BLOX Racing Silicone Turbo Inlet Hose 3in — WRX 2015–2020 — $135.50, the standard-wall version.
- BLOX Racing Air Box Intake Hose — WRX and STI 2008–2020 — $73.11. The accordion hose between the airbox and the inlet — the other rubber piece that splits with age.
Couplers and Small Parts
- BLOX Racing Intercooler Coupler Hose Kit — WRX 2008–2019 — $50.69, with the 2002–2021 kit at $19.50. Couplers are boost leaks waiting for a date; fresh silicone and good clamps are the cheapest reliability on this page.
- BLOX Racing Radiator Cap 1.3 Bar — WRX 2002–2027 — $22.42. A higher-pressure cap raises the coolant's boiling point; the cap is also a wear item — a tired spring vents pressure early and reads as a cooling problem that isn't.
FAQ
How do I know my turbo inlet is failing? Tears at the turbo end, oil weep at the joints, and a car that idles or cruises leaner than it should. On a VA WRX, if the inlet is original, age alone is a reason to look.
Do the control arms need an alignment after? Yes — that's the point of them. Install, set ride height, align with the rear camber you actually want.
Silicone or factory rubber for couplers? Silicone handles heat and pressure cycles far better and doesn't harden the way rubber does. For any hose you plan to keep for years, silicone is the answer.
Are these parts I can install at home? Couplers and the radiator cap, easily. The inlet hose is fiddly but doable. Control arms need an alignment appointment after — budget for it.